COPPER TUBES IN COILS

COPPER TUBES IN COILS


Specifications.

BS EN 12449:1999 Copper and copper alloys. Seamless, round tubes for general purposes.

Brand:
Cu-DHP with the chemical composition of BS EN 12449:1999;
SF-Cu withthe chemical compositionof DIN 1787-73 (repealed)

Method of manufacturing: Expanded

Purpose: General purpose tubes (used in all industries).

Requirements:

Designation Standard

Mark

* Outside diameter, mm

* Wall thickness, mm

*The length of pipe in the coil, m

State

BS EN 12449:1999

Cu-DHP

4,76-18

0,3-2,5

at least
60

R200, R290

The technical requirements for harmonization

SF-Cu
( withthe chemical compositionof DIN 1787-73(repealed))

4,76-18

0,3-2,5

at least
60

F22, F29

The geometric dimensions according to BS EN 12449:1999.


State and mechanical properties of the material:

Designation
Standard

State

Ultimate strength,
MPa, no less

Relative
Elongation A 5%
at least

BS EN 12449:1999

R200

200

40

R290

290

5

The technical requirements for harmonization

F22

220

40

F29

290

6

Upon request drawn pipes can be manufactured in the coils of the following types:

- Free winding coils (BT);

- Bay layered orderly winding (CU);

- Bay flat spiral winding (BS).


The mass of tubes in coils with a layer wounded:

The mass of tubes in coils should not exceed 110 kg. Allowed mass of tubes in coils of 110 kg.

The minimum and maximum mass of coils can be set in consultation with the consumer.

Bay Size: inner diameter - 610 mm, outside diameter - less than 1100 mm, height - not exceeding 450 mm.

The outer and inner surface of the tubes must be clean and smooth.

Tubes should be sealed. Control discontinuities produced by the eddy current flaw detector.

_______________

* Requirements for the geometric dimensions of tubes agree with the consumer in the order.



Back to section