Copper strips cold rolled
![]() |
Standart documents:
GOST 1173-2206 - foil, ribbons, sheets and plates of brass. Specifications
DSTU GOST 1173:2007
TU U 27.4-00195452-015-2003 - Tubes, rods, strips and sheets made of special grades of copper.
Specifications
BS EN 1652:1998 - Copper and copper alloys. Plate, sheet, strip, tape drives, and general purpose.
Material:
M1 M1ð, M2, M2ð, M3, M3ð with chem. composition according to GOST 859-2001 (DSTU GOST 859:2003)
Cu-FRTP, Cu-DLP, Cu-DHP with the chemical. composition of BS EN 1652:1998
Cu-FRTP, Cu-DLP, Cu-DHP, E-Cu 57 with chemical composition according to TU U 27.4-00195452-015-2003
Purpose: General purpose sheets (used in various industries)
Thickness: 0.4 mm to 12.0 mm
Width: 600 mm
Length: 500 mm to 2000 mm
Requirements for hire:
1. The geometric dimensions according to GOST 1173-2206 (DSTU GOST 1173:2007) and BS EN 1652:1998:
2. Mechanical properties of sheets GOST 1173-2206 (DSTU GOST 1173:2007) and BS EN 1652:1998:
Normative
|
State |
Ultimate strength,
|
Relative
| |
GOST 1173-2006
|
soft |
200–260 |
42 | |
semisolid |
240–310 |
15 | ||
solid |
at least 290 |
6 | ||
Normative
|
State |
Ultimate strength,
|
Relative
| |
for thickness up to and
|
äëÿ òîëùèíû ñâûøå 2.5 ìì | |||
BS EN 1652:1998 |
R220 |
220–260 |
33 |
42 |
R240 |
240–300 |
8 |
15 | |
R290 |
290–360 |
4 |
6 |
Camber sheets up to 4.0 mm should not exceed 5 mm to 1 m in length, thickness exceeding 4,0 mm - 8 mm to 1 m in length.
Deflection for cold-rolled sheet or semi-solid state should not exceed 1 mm per 100 mm width and 20 mm for 1 m length of the sheet. The deflection of the sheets of soft state is not regulated.
Back to section