COPPER SHEET HOT-ROLLED

COPPER SHEET HOT-ROLLED


Standard documents:
GOST 1173-2006 - foil, ribbons, sheets and plates of brass. Specifications
DSTU GOST 1173:2007
TU U 27.4-00195452-015-2003 - Tubes, rods, strips and sheets made of special grades of copper.


Specifications
BS EN 1652:1998 - Copper and copper alloys. Plate, sheet, strip, tape drives, and general purpose.


Material:

M1 M1r, M2, M2r, M3, M3r with chem. composition according to GOST 859-2001 (DSTU GOST 859:2003)

Cu-FRTP, Cu-DLP, Cu-DHP with the chemical. composition of BS EN 1652:1998

Cu-FRTP, Cu-DLP, Cu-DHP, E-Cu 57 with chemical composition according to TU U 27.4-00195452-015-2003


Purpose: General purpose sheets (used in various industries)


Requirements for hire:

1. The geometric dimensions according to GOST 1173-2006 (DSTU GOST 1173:2007) and BS EN 1652:1998.


Thickness: from 4.0 mm to 25.0 mm


Width: 600 mm to 1000 mm


Length: 1000 mm to 2000 mm


Dimension for thickness, width and length according to GOST 1173-2006 (DSTU GOST 1173:2007), BS EN 1652:1998.


2. The mechanical properties of the material in accordance with GOST 1173-2206 (DSTU GOST 1173:2007) and BS EN 1652:1998.

Normative
document

Ultimate strength,
MPa

Elongation δ,%,
at least

δ10

δ5

GOST 1173-2006
(DSTU Standard 1173:2007)

at least 200

30

BS EN 1652:1998

not regulated

Mechanical properties of hot-rolled sheet with thickness over 12 mm is determined by the customer's request.


The deflection is determined by agreement between manufacturer and consumer.



Back to section