COPPER WATER TUBES IN COILS

COPPER WATER TUBES IN COILS


Standard documents:
DIN EN 1057:2006 Copper and copper alloys.  Seamless round copper for sanitary-technical  tubes water, gas, heating and industrial use. 

Brand: Cu-DHP with the chemical composition of DIN EN 1057:2006. 


Method of manufacturing: Expanded


Purpose:  tubes are used in drinking water systems, hot and cold water heating, cooling, sanitation, water treatment and supply. 


Requirements: 

Designation Standard 

Mark 

Outer diameter * 
mm 

Wall Thickness * 
mm 

The length of pipe in the bay * 
m

State 

DIN EN 1057:2006

Cu-DHP

6-22

0,5-1,5

25, 50

R220

The geometric dimensions according to DIN EN 1057:2006. 


State and mechanical properties of the material:
 

Designation 
Standard 

 State

 Ultimate strength, 
MPa 
at least 

Relative 
Elongation A 5% 
at least 

DIN EN 1057:2006

R220

220

40


Upon request expanded  tubes can be manufactured in the bays of the following types: 

 - Free winding coils (BT); 
 - Coils layered orderly winding (CU); 
 - Coils flat spiral winding (BS). 

 The mass of pipes in coils with a layer wounded: 

 The mass of tubes in coils should not exceed 110 kg.  The minimum and maximum mass of coils can be set in consultation with the consumer.  In agreement with the consumer mass coils of 40 kg to 70 kg. 

 Surface Quality 

 The outer and inner surface of the tubes must be clean and smooth. 

 The inner surface of the tubes must not contain the carbon film.  The inner surface of tubes water content of residual carbon must be less than 0.20 mg / dm 2. 

 The tubes should be sealed.  Control discontinuities produced by the eddy current flaw detector. 

 _______________ 

 * Requirements for the geometric dimensions of tubes negotiate with the customer when ordering. 




Back to section
ðåéòèíã ñàéòîâ
ðåéòèíã ñàéòîâ